How to pick good bed wedge for heartburn problems?

Subscribe

Stay Up To Date!

7 Responses to “How to pick good bed wedge for heartburn problems?”

1. 

   jeffsmoola

   August 12, 2009 at 11:01 pm #

   Some great summaries of studies regarding bed wedges can be found at BedLift.com – See this:
   " Using continuous monitoring of pH (acidity) within the esophagus among several alternative positions at rest, this randomized clinical trial detected a significant decrease in the time that the esophagus was exposed to highly acid conditions when using a foam wedge to elevate the head, and also showed a decrease in the time necessary for the acid to be cleared. Interestingly, use of a wedge-shaped mechanism was significantly more effective than elevation through the use of standard bed blocks."

   and
   " METHODS: The subject was placed supine on a standard hospital bed. The head of the bed was then elevated to 30 degrees according to 2 protocols: (1) supine for 10 minutes without leg elevation alternating with 10 minutes of side-lying, or (2) supine for 10 minutes with leg elevation at 10 degrees alternating with side-lying every 10 minutes. Body displacement and mean sacral interface pressures in both protocols were compared by using repeated measures analysis of variance.

   RESULTS: The 30-degree head-up position with 10-degree leg elevation significantly reduced the amount of body displacement at the acromion compared with no elevation of the legs. There were no significant differences in mean sacral interface pressure in either position. C

   CONCLUSION: Leg elevation at 10 degrees in the 30-degree head-up position was effective for reducing body displacement at the acromion; it was not effective for reducing sacral interface pressures."

2. 

   Roger K

   August 12, 2009 at 11:01 pm #

   Trial and error. I am not certain there there is an "exact" best elevation – certainly not one elevation for everyone.

   An inexpensive option would be to get some wood to put under head end of the bed frame, or the posts, or whatever is at the top end. Arrange them to safely support the bed at whatever height you want to try. Adjust it higher or lower as needed.

   Good luck – hope you can find the solution that works for you.

3. 

   Noemail

   August 12, 2009 at 11:01 pm #

   You can find more here : bedlift.com

   Good luck.

4. 

   Jimbo

   August 12, 2009 at 11:01 pm #

   It’s all personal preference. Any amount of lift is good, and the recommended 6-8 inches you’ve heard is about the mean size that most wedges come in. I couldn’t seen using something over 10" because the amount of lift seems to me to be too great and would compromise comfort. 5 or 6 inches isn’t really anymore than 2 pillows would be stacked. If I were you I’d go with a 7 or 10 inch wedge, depending on your height.

5. 

   Justin

   August 17, 2009 at 9:12 pm #

   Love the new look. I enjoyed the article. Thanks for the content.

6. 

   Ed

   August 26, 2009 at 8:13 pm #

   Raising your headboard with blocks of wood or bricks will lead to your mattress sagging and if discovered by a third party inspector during a warranty claim against the mattress manufacturer will void your warranty. Look for a wedge that fits between the mattress and the box spring and supports the whole mattress, like the MediWedge. A 4″ lift is comfortable to sleep on, and with a 6″ lift, if you toss and turn, you will work your way to the foot of the bed. Since you are inclining the whole mattress, it does not matter how tall you are and you can sleep on your back, side or stomach.

7. 

   Adrain

   May 21, 2011 at 9:02 am #

   When you go to bed try lying on your left side, this is a great heartburn cure!

Leave a Reply